Installing a pin header on a sb5100

Close

In this video you will be able to see how to open the modem and how to solder the pin header on the board of the modem.

 

0 Comments

Installing the firmware to a sb5100 using the blackcat software

Close

In this video you will learn how to use the blackcat usb software to intall the firmware to a sb5100

 

Comments Off on Installing the firmware to a sb5100 using the blackcat software

Installing the firmware on a sb5100 using Toms Jtag Utility 1.3

Close

In this video you will learn how to use the jtag utility software. You will see how to backup your modem before you do anything and how to install the noisy boot loader and sb5100mod firmware.

 

Comments Off on Installing the firmware on a sb5100 using Toms Jtag Utility 1.3

Installing the firmware on the Blackcat USB board

Installing a new firmware to the blackcat usb jtag is pretty simple. You can literally install a new firmware to the board in about 20-30 seconds.

Im doing this on a blank blackcat usb jtag but the process is the same if you are just upgrading the firmware version on the board or if you want to use the SPI fimrware for the sb6120 modem or any other SPI modem that gets added to the support list.

If you are upgrading the firmware you need to make sure that you put the board on DFU mode by moving the 2 little switches to the pin header side, after you have done that press the reset button on the board and the software should take you to the screen shown in the video.


Play Video

Comments Off on Installing the firmware on the Blackcat USB board